Create procedural platforms with expanded curbs

[Ter160 4]

 

Hello, good afternoon, after the solution of phase 1, about adding ramps to the procedural platforms, it is time for phase 2, based on the same as the previous one, but with expansion of the curbs, both one and both sides

 

The curious thing is how DoveTailGames has included it in the Developer template folder, when you open the blender the platform appears with two expanded curbs or something like that in black, without textures, I think

 

 

Here is the screenshot for the test:

 

[Sjef61 2,302]

Old example.

After update TS1015,  placing a texture has been changed.

Add new texture as you normal do

[Ter160 4]

4 minutes ago, Sjef61 said:

Old example.

After update TS1015,  placing a texture has been changed.

Add new texture as you normal do

Ok, but how do I expand the curbs to achieve a result the same as the mesh in the capture?

[Ter160 4]

On 5/13/2024 at 8:44 PM, Ter160 said:

Ok, but how do I expand the curbs to achieve a result the same as the mesh in the capture?

Without an answer I will not be able to continue with this question

[Ter160 4]

Result created by DTG: 

 

Edited May 16 by Ter160

[Dutch TrainSimulations 1,728]

so if i understand this correct you wil try to create as in the picture..? 

 

[Ter160 4]

2 uren geleden, Rob_zeeland zei:

so if i understand this correct you wil try to create as in the picture..? 

 

Yes

[Dutch TrainSimulations 1,728]

ok..

 

select the vertical face en then CTRL-R and enter

 

now selct the top face of the 2 faces you just created with ctrl_r then press E to extrude

 

 

now delete the front and back faces to keep it open. now you can experiment a bit with the measurements..

 

check also this youtube.. the guy use an older version of blender but it might help alot for the basics..

 

https://www.youtube.com/@tony3133

Edited May 17 by Rob_zeeland

[Ter160 4]

29 minuten geleden, Rob_zeeland zei:

ok..

 

select the vertical face en then CTRL-R and enter

 

now selct the top face of the 2 faces you just created with ctrl_r then press E to extrude

Ok, i will look

[Ter160 4]

Result:

 

 

Now the problem is the ramp

 

 

Result of the operation for ramp, the shape of the curb is wrong, once I went down the ramp to reach ground level

 

[Dutch TrainSimulations 1,728]

select the edges..

 

[Ter160 4]

25 minutes ago, Rob_zeeland said:

select the edges..

 

Let me know how I achieved it to obtain your result

[Dutch TrainSimulations 1,728]

Select the edges and move them up and down..see what happens

 

[Ter160 4]

50 minutes ago, Rob_zeeland said:

Select the edges and move them up and down..see what happens

 

ok